a. Note the orientation of the connector on the new storage drive. Then, flex both sides of the adapter
and align the four pins
Note: Do not touch the circuit board (if accessible) of the 2.5-inch storage drive.
Figure 31. Installing the storage drive into the adapter
b. Align the four tabs on the adapter with the corresponding notches
storage drive as shown until the tab
installed into the converter.
Figure 32. Installing the adapter into the converter
116
P920 Hardware Maintenance Manual
1
with the corresponding holes in the storage drive.
2
snaps into position. The adapter with the storage drive is
1
in the converter. Then, slide the