Lenovo ThinkStation P920 Hardware Maintenance Manual page 149

4. To remove the M.2 solid-state drive holder, pivot the tab
function bracket. Then, grasp the M.2 solid-state drive holder by its edges and gently pull it out of the
M.2 solid-state drive slots.
Notes:
• The M.2 solid-state drive holder might fit tightly into the M.2 solid-state drive slots. If necessary,
alternately move each side of the holder a small amount until it is removed from the slots.
• Depending on the model, the M.2 solid-state drive holder might look slightly different from the
illustration.
Figure 78. Removing the M.2 solid-state drive holder
5. Turn the mounting stud 90-degree counterclockwise to release the heat sink. Then, lift the heat sink off
the M.2 solid-state drive holder.
Figure 79. Removing the heat sink from the M.2 solid-state drive holder
1 upward to open the latch
.
Chapter 9 Hardware removal and installation
2 inside the multi-
141