FireClass FC501-HK Installation Manual page 2

This Fire Control panel can only be programmed using
the Software FireClass Console release 1.0 or higher.
Control panel FW ver. 1.0 or higher.
TYCO shall not assume the responsibility for damage
arising from improper application or use.
Installation of this Control panel must be carried out
strictly in accordance with the instructions described in
this manual and in compliance with the local laws and
bylaws in force.
The FC501-L, FC501-H and FC501-HK Fire Control
panels comply with the essential requirements of stan-
dards EN54-2; EN54-4 and EN54-21.
Contents of the box
The control panel is contained in a box. Listed below
are the contents:
Ø the plastic cabinet (backplate and cover) with the
motherboard and the power supply Switching as-
sembled.
Ø The Quick Start Guide.
Ø A transparent plastic bag containing:
- A CD-ROM containing the Installation and User
manuals and the FireClass software console to
manage the panel;
- A second transparent plastic bag containing:
-the KST thermal Probe;
- Two 3.9 kOhm resistors;
- a red and a black cable L = 300 mm with a faston
terminal to connect batteries;
- a black cable L = 300 mm with two faston terminal to
connect batteries. Proceed carefully to unpack the
contents and dispose of recyclable materials in ac-
cordance with the local law.
Recycling information
The manufacturer recommends that customers dispose of their used
equipment (panels, detectors, sirens, and other devices) in an environmen-
tally sound manner. Potential methods include reuse of parts or whole prod-
ucts and recycling of products, components, and/or materials.
Waste Electrical and Electronic Equipment (WEEE)
Directive
In the European Union, this label indicates that this product
should NOT be disposed of with household waste. It should be depos-
ited at an appropriate facility to enable recovery and recycling.
NOTE- The FC501 Fire control panel can support several address-
able devices (Detectors, Modules, Manual call Points, etc). The pres-
ent manual includes the instructions for their programming, but for
further information on those devices and their accessories, please
visit: www.fireclass.net, logging in the Reserved Area, under Instal-
lation Manuals.
The manufacturer reserves the right to change the technical specifi-
cations of these products without prior notice.
Tyco Fire & Security GmbH
Victor von Bruns-Strasse 21
8212 Neuhausen am Rheinfall
Switzerland
DoP-2015-4218 (FC501-L)
DoP-2015-4219 (FC501-H)/(FC501-HK)
EN 54-2:1997+A1:2006 EN54-4: 1997+A1:2002+A2:2006 EN 54-21
Control and indicating equipment with integrated power supply
equipment for fire detection and fire alarm systems for buildings
with alarm transmission and fault warning routing equipment.
EXPECTED OPTIONS
Fault signals from points
Dependencies on more than one alarm signal: type A and B
Delays to outputs
Disablement of addressable point
Test condition
Output to fire alarm device
EN 54-2 ESSENTIAL CHARACTERISTICS
Performance under fire conditions
Response delay (response time to fire)
Operational reliability
Durability of operational reliability, Temperature resistance
Durability of operational reliability, Vibration resistance
Durability of operational reliability, Electrical stability
Durability of operational reliability, humidity resistance
EN 54-21 ESSENTIAL CHARACTERISTICS
Performance of transmission
Operational reliability
Durability of operational reliability, Temperature resistance
Durability of operational reliability, Vibration resistance
Durability of operational reliability, Electrical stability
Durability of operational reliability, humidity resistance
EN 54-4 ESSENTIAL CHARACTERISTICS
Performance of power supply
Operational reliability
Durability of operational reliability, Temperature resistance
Durability of operational reliability, Vibration resistance
Durability of operational reliability, Electrical stability
Durability of operational reliability, humidity resistance
Tyco Fire & Security GmbH
Victor von Bruns-Strasse 21
8212 Neuhausen am Rheinfall
Switzerland
DoP-2015-4211 (FC500IP in FC501-L/FC501-H/FC501-HK)
EN 54-21
Alarm transmission and fault warning routing equipment for fire
alarm systems installed in buildings.
EN 54-21 ESSENTIAL CHARACTERISTICS
Performance of transmission
Operational reliability
Durability of operational reliability, Temperature resistance
Durability of operational reliability, Vibration resistance
Durability of operational reliability, Electrical stability
Durability of operational reliability, humidity resistance
The Declarations of Performance (DoP) can be found
on the product webpage at www.fireclass.net.
0051
13
Passed
Passed
Passed
Passed
Passed
Passed
Passed
Passed
Passed
Passed
Passed
Passed
Passed
Passed
Passed
Passed
Passed
Passed
Passed
0051
13
Passed
Passed
Passed
Passed
Passed
Passed