Jumper Settings; How To Set Jumpers - Advantech ASMB-782G2-00A1E User Manual

1.8

Jumper Settings

This section provides instructions on how to configure your motherboard by setting
the jumpers. It also includes the motherboard default settings and your options for
each jumper.
1.8.1

How to set jumpers

You can configure your motherboard to match the needs of your application by set-
ting the jumpers. A jumper is a metal bridge that closes an electrical circuit. It consists
of two metal pins and a small metal clip (often protected by a plastic cover) that slides
over the pins to connect them. To "close" (or turn on) a jumper, you connect the pins
with the clip. To "open" (or turn off) a jumper, you remove the clip. Sometimes a
jumper consists of a set of three pins, labeled 1, 2, and 3. In this case you connect
either pins 1 and 2, or 2 and 3. A pair of needle-nose pliers may be useful when set-
ting jumpers.
1.8.1.1 CMOS and ME clear (JCMOS1)
The ASMB-782 motherboard contains a jumper that can erase CMOS data and reset
the system BIOS information. Normally this jumper should be set with pins 1-2
closed. If you want to reset the CMOS data, set JCMOS1 to 2-3 closed for just a few
seconds, and then move the jumper back to 1-2 closed. This procedure will reset the
CMOS to its default setting.
Table 1.3: JCMOS1
Function
* Keep CMOS data
Clear CMOS data
* default setting
1.8.1.2 ME update (JME1)
The ASMB-782 contains a jumper that can update for ME firmware. Normally this
jumper should be set with pin 1-2 closed. If you want to update ME firmware, set
JME1 to 2-3 closed to disable ME for new ME firmware update.
Table 1.4: JME1
Function
*Lock ME update
ME update
ASMB-782 User Manual
Jumper Setting
1 2 3
1-2 closed
1 2 3
2-3 closed
Jumper Setting
1 2 3
1-2 closed
1 2 3
2-3 closed
8