Setting Parameters; Table 8: Lcd Display In Operation - Eaton M-Max series Quick Start Manual

M-Max Series adjustable frequency drive

Setting parameters

The following table shows an example of how you can select and set parameters.

Table 8: LCD Display in Operation

Sequence Commands
0
1
2
24
Display
READY RUN
REF
MON
PAR
FLT
FWD REV
READY RUN
BACK
REF
MON
RESET
PAR
FLT
FWD REV
OK
READY RUN
REF
MON
PAR
FLT
FWD REV
Display in automatic
alternation
READY RUN
REF
OK
MON
PAR
FLT
FWD REV
For more information visit: www.eaton.com
Description
Measured value 1.1
STOP ALARM FAULT
The display changes automatically with
the value of the output frequency 0.00 Hz
(at STOP).
I/O KEYPAD BUS
By actuating the BACK/RESET button, you
STOP ALARM FAULT
activate the menu level (arrow flashes).
I/O KEYPAD BUS
You can select the individual main menus
with the two arrow keys (closed circuit):
• REF = Set point input (Reference)
• MON = Operational data indicator
(Monitor)
• PAR = Parameter levels
• FLT = Fault log (FAULT)
Use the OK button to open the selected main
menu.
The numerical first value is always shown
STOP ALARM FAULT
from the selected main menu.
Example: Main menu PAR, Parameter P1.1
The display automatically switches between
the parameter number and the defined value.
I/O KEYPAD BUS
Use the OK button to activate the selected
STOP ALARM FAULT
parameter.
The value (1) flashes.
I/O KEYPAD BUS
February 2010
MN04020002E