Activating a Stored Profile
To activate a stored profile, type the following command at the [ CMD: ] prompt:
copy profile to pA
For example, to activate p1, type:
copy p1 to pA
The 7500 will activate the profile requested and respond:
[ pA updated ].
See NOTE below.
Replacing One Stored Profile With Another
To replace one stored profile with another, type copy replacement profile to replaced profile. For
example, type:
copy p0 to p1
replaces the values of p1 with the values of p0.
See NOTE below.
In all of the above command procedures, the word "to" is optional. Examples of the command
without "to" are:
copy p1 pA
copy pA p1
copy p0 p1
CHAPTER 5: ASYNCHRONOUS DCE CONFIGURATION
85