Table of Contents
Advertisement
CHAPTER 8: INSTALLING THE 7500
7 .
Close the door by hooking the hinges under the front housing, then snapping the rear tabs in
place.
8.
Connect the telephone line cord to the jack labeled LINE.
9.
Orient the power supply plug properly, then connect the cord to the 7500 into the connector
labeled POWER.
10.
Connect the male end of the EIA-232D cable to the connector labeled Port 1.
11.
Connect the other end of the EIA-232D cable to your modem.
12.
Plug the power cord into an AC power outlet. The 7500 will automatically run a self test. For
new sets, enter SPID and perform a self-test.
Plugging attaching the telephone line into the wall jack, make sure that you do
not need either the NT1 or the Terminating Resistor Adaptor. If you need either,
see the special installation instructions provided at the end of this section.
13.
Plug the telephone line cord into the telephone wall jack.
Stand-Alone Multipurpose Enhancement DCE Configuration
This configuration consists of the basic 7500 plus the Multipurpose Enhancement board. Follow
Steps 1 through 9 listed in the Stand-Alone Dual Port Asynchronous DCE Configuration section and
then continue steps listed below.
1. Connect the other end of EIA-232D cable (from Port 1) to data terminal or computer port.
2. If you are using the automatic calling unit functionality, connect a 25-pin EIA cable between the
RS-366 interface (Port 2) and your computers RS-366 automatic calling interface.
3. Plug the power cord into the AC outlet. For new sets, enter SPID and perform a self-test.
4.
Plug the telephone line cord into the telephone line jack.
Stand-Alone High Speed Synchronous DCE Configuration
This configuration consists of the basic 7500 plus the High Speed Synchronous Enhancement board.
Follow Steps 1 through 9 listed in the Stand-Alone Dual Port Asynchronous DCE Configuration
section and then continue steps listed below.
1. Connect a V.35 adapter cable (packaged with the enhancement board) to Port 2.
2. Connect a V.35 cable between the adapter and the V.35 data terminal.
3. Plug the power cord into the AC outlet. For new sets, enter SPID. Perform self-test.
4. Plug the telephone line cord into the telephone line jack.
116
Advertisement
Table of Contents
