Table of Contents
Advertisement
CHAPTER 3: FRONT PANEL FEATURE ACCESS
Remote Loopback Self-Test (Asynchronous Only)
To Run Remote Loopback Self-Test (Asynchronous Only)
This remote loopback test has an internal data generator/checker. To perform this test, you must have
established a data call before you initiate the test. Attempting to run a Remote Loopback Self-Test
without a data call will return you to the (Home) display.
Starting from the (Home) display, press
1.
[
] until [ TEST-RESET? ] is
NEXT/NO
displayed.
2. Press [
ENTER/YES
[
] until [ RL SELFTEST? ] is
NEXT/NO
displayed or until the correct Remote
Loop Selftest is displayed if you have a
dual port configuration.
3. Press [
ENTER/YES
4. Press [
ENTER/YES
Resetting Options
Single Port Configuration
The Reset Options menu allows you to reset all data options to the values set in the factory before
the unit was shipped. See CHAPTER 4 for the factory option settings.
Press [
] from the (Home)
1.
NEXT/NO
display until [ TEST-RESET? ] is
displayed.
Press [
2.
ENTER/YES
[
] until [ RESET OPTIONS? ] is
NEXT/NO
displayed.
3. Press [
].
ENTER/YES
26
], and then press
] to run the test.
] to end the test.
], and then press
[ TEST-RESET? ]
is displayed.
[ AL SELFTEST? ] is displayed or
[ AL SELFTEST P1? ] or [ AL SELFTEST P2? ]
is displayed (dual port configuration).
If the test passes, the display shows
[ TEST PASSED ] alternating with
[ END SELFTEST? ].
If test fails, the display shows [ TEST FAILED ]
alternating with [ END SELFTEST? ].
The display returns to (Home).
[ TEST-RESET? ] is displayed.
[ RESET OPTIONS? ] is displayed.
[ ARE YOU SURE? ] is displayed.
Advertisement
Table of Contents
