Table of Contents
Advertisement
The 7500 will display the current value and the possible values for that option and prompt:
[ Type new value (or Q to quit): ]
3 . Type the new value (for example, auto) and press [
4. The 7500 will display the new values and prompt again:
[ Type option name (or Q to quit): ]
5. Type the name of the next option that you want to change and repeat Steps 2 and 3.
6.
When you are finished changing options, type q to quit.
7. The 7500 will prompt:
[ Do you want to save the change(s) you made (Y or N)? ]
Type y to save new values.
The 7500 responds:
[ p1 updated ]
Type n to cancel new values.
The 7500 responds:
[ No changes to p1 ]
8. The 7500 will prompt:
[ Do you want to activate this profile now (Y or N)? ]
Type y to activate p1.
The 7500 responds:
[ p1 copied to pA ]
Type n to not activate p1.
The 7500 responds:
[ p1 not copied to pA ]
Another way to change options is to use the set command (see the next section in this
chapter, Setting Options: Changing Your Active Profile, pA).
CHAPTER 5: ASYNCHRONOUS DCE CONFIGURATION
] when you are finished.
RETURN
83
Advertisement
Table of Contents
