Table of Contents
Advertisement
CHAPTER 8: INSTALLING THE 7500
Stand-Alone Asynchronous DTE Configuration
1 . Remove the 7500 from the box. For installed set, disconnect power cord.
2 . Open the door on the 7500. First, insert a pen into the small hole located near the LINE label.
on the set's back panel.
Next, push in on the tab in the hole while you pull up on that side of the door.
Repeat the procedure on the other side of the door.
Lift off the door and set it aside.
Removing the Door
Figure 30:
111
Advertisement
Table of Contents
