Table of Contents
Advertisement
Viewing Options, Without Help Menu
If the 7500 is configured for only one port (i.e., no Second Asynchronous Enhancement Board
installed), follow the instructions below.
If you have a Second Asynchronous Enhancement Board installed, the option named Setup
determines which port's options are viewed when using the Without Help menu. As Table D indicates,
the Setup option is in the fourth display position of List 1 (L1). When using the Without Help menu to
view options, make sure to check the status of the Setup option to determine which port's options you
are viewing. The Setup option values are as follows:
If Setup = B or 1, port 1's options will be displayed.
If Setup = 2, port 2's options will be displayed.
Figure 20 illustrates the Without Help Menu for viewing the option values currently in effect. You
can only view the options from this menu; you cannot change any of them.
1.
] from the (Home)
Press [
NEXT/NO
display until [ VIEW OPTIONS? ] is
displayed.
2.
Press [
].
ENTER/YES
3 . Press [
].
NEXT/NO
4. Press [
].
ENTER/YES
5 . When you are finished viewing your
desired options, press [
or twice until [ DONE? ] is displayed.
6. Press [
] to exit.
ENTER/YES
CHAPTER 3: FRONT PANEL FEATURE ACCESS
[ VIEW OPTIONS? ] is displayed.
[ WITH HELP? ] is displayed.
[ WITHOUT HELP ] is displayed.
[ L1:XXXXXXXXXXXXX ] is displayed.
If you are configured as asynchronous DCE or
DTE, press [
options.
[ DONE? ] is displayed.
] once
NEXT/NO
The display returns to (Home).
] to display list 2's
NEXT/NO
47
Advertisement
Table of Contents
