Table of Contents
Advertisement
CHAPTER 4: DEFINITIONS OF 7500 OPTIONS
To change the Attention sequence to @@@, for example, type set attention @ . Note that you
need only type the new character once while changing the value.
Without Help
hexadecimal
Possible values include any printable or control characters except NUL(Ctrl@), SOH(CtrlA),
CAN (CtrlX), NAK (CtrlU), BS (CtrlH), DC3 (CtrlS), DC1 (CtrlQ), and DEL.
Autoadjust
Configurations: Asynchronous DCE, Asynchronous DTE
Data Protocols: X.25, Mode 2, Mode 3
If Autoadjust is on, the 7500 automatically adjusts to the Speed and Parity of your attached data
terminal when you press [
[ CMD: ] prompt (providing local mode is set to CMD).
Failure to complete this sequence within 15 seconds may result in improper speed setting.
If Autoadjust is off, you must set Speed and Parity with the set command from an attached
terminal from the available menus on the 7500 front panel.
Without Help
52
Asynchronous DCE and Asynchronous DTE
Option Values For Attention
Front Panel
With Help
+ + +
2b
* * *
2a
40
@ @ @
# # #
23
2d
- - -
N/A
00
N/A
02 - 7E
N/A = Not available
], then type AT. Pressing [
BREAK
Asynchronous DCE and Asynchronous DTE
Option Values For Autoadjust
Front Panel
With Help
0
OFF
1
ON
Factory Value
CMD
Mode
DCE
DTE
+
X
*
@
#
X
—
off
See note
below
] after this sequence will display the
RETURN
Factory Value
CMD
Mode
DCE
DTE
off
X
X
on
Advertisement
Table of Contents
