Table of Contents
Advertisement
Service Profile Identifier (SPID)
Use this display to enter the Service Profile Identifier (SPID) for each unit; your system
administrator will give you the 7500's SPID number. Your SPID number must be entered exactly as it
is given to you — including all 0s.
This number identifies your 7500 to the network and should not be changed unless
your system administrator so indicates. Changing the value could result in loss of
service.
The following steps show how, from the front panel of the 7500, to store the SPID you have been
given by your system administrator. The steps shown are from the (Home) display. If you are not at the
(Home) display, press [
NEXT/NO
example below, the SPID to be stored is 234567.
To Enter the SPID
1.
Starting from the (Home) display, press
[
] and [ PROGRAM SPID? ] is
NEXT/NO
displayed.
2.
Press [
].
ENTER/YES
Press [
] or [
3.
NEXT/NO
correct digit is displayed and then press
[
] to move the cursor one
ENTER/YES
position to the right.
(Note: 0-9, blank, and E can be
entered.)
4.
Repeat the previous step for each digit
in a number.
After all digits have been entered, press
5.
[
] to place the cursor in the
ENTER/YES
next position. Press [
[
] until E is displayed. Press
BACK
[
].
ENTER/YES
Entering a Blank (pressing [
[
] ) places the cursor back in the first display position. This enables you to correct
ENTER/YES
any errors you may have made.
] and [
] at the same time to return to the (Home) display. In the
BACK
] until the
BACK
] or
NEXT/NO
] or [
NEXT/NO
BACK
CHAPTER 3: FRONT PANEL FEATURE ACCESS
[ PROGRAM SPID? ]
is displayed.
[ ID:0000000000 ] is displayed.
The correct digit is entered and displayed; for
example:
[ ID:2000000000 ]
For example:
[ ID:2345670000 ]
For example:
[ ID:234567E000 ]
(Note: E stores the number in memory and
then returns to the (Home) display.)
] until a blank appears and then pressing
49
Advertisement
Table of Contents
