Table of Contents
Advertisement
CHAPTER 5: ASYNCHRONOUS DCE CONFIGURATION
Automatic Speed and Parity Adjustment
The 7500 data module can automatically adjust to the Speed and Parity of your data terminal. If
you are not sure the 7500 and your data terminal are operating at the same speed, or if you need to
change your 7500's Speed or Parity, follow the procedure below.
ACTION
Automatic Speed and Parity
adjustment
If the [ CMD: ] prompt does not appear, refer to the definition of Autoadjust in CHAPTER 4:
DEFINITIONS OF 7500 OPTIONS.
72
PROCEDURE
1 . Turn on your data terminal or PC.
If you are using a PC, make certain your
communications software is configured properly at
the speed and parity you want to use.
2. Press [
], type AT, and press [
BREAK
The 7500 will automatically adjust to the Speed and
Parity of your data terminal, and the [ CMD: ] prompt
will appear on your terminal screen.
].
RETURN
Advertisement
Table of Contents
