Ja-60P - Motion Detector Installation - jablotron JA-60 COMFORT Installation Manual

opening of door detector (bottom
view)
Fig.7
• Use DIP switch no. 1 to select if the reaction of
the system to the door opening should be in-
stant or delayed (main entrance door). Switch
no. 2 must stay in the OFF position. See fig. 8.
• check that all 3 terminals in the detector are
connected together with short connecting
loops.
• install other JA-60N magnetic detectors the
same way.
• Be sure to leave all JA-60N detectors un-
covered and without batteries installed.

3.2. JA-60P - motion detector installation

By using the provided bracket, the JA-60P detector can be installed on the wall or in a corner. The recommended installa-
tion height is from 2 to 2.5 meters above the floor. The detector's coverage area is up to 12 meters and it has a detection
angle of 120° (see fig. 11). Do not place the detector close to any heating/cooling vents or near any other object that often
changes temperature. The JA-60P should not be placed near any item that generates a strong electromagnetic signal
(transmitters, electronic regulators etc.). Avoid locations that have intense air circulation.
Alarm system JA-60 "COMFORT"
• Open the detector's cover by pressing the internal pawl – see fig. 7
• Install the detector to the desired location using the two provided screws.
• Be sure that the antenna is vertical (pointing up or down)
• Attach the magnet, using the provided screws, to the moving part of the door or
window, and attach its cover. The gap between the detector and magnet should
not be wider than 5mm when the door is closed (see fig. 8)
• Warning: neither the detector nor the magnet should be fixed directly to a metal
surface. If there is no other choice, an insulating pad (plastic, wood etc.) 5mm
thick or more should be used under the detector and the magnet.
- 6 -
Fig.8 – detector's mount and
reaction setting
MDY51319