Motion Detector Installation - jablotron Azor User Manual

Motion detector installation

− The detector should be installed in the corner (facing the room), 2 to 2.5m above
the floor. The detector is able to cover an area of up to 10 x 10m*.
− The detector holder should be fixed so that the sensor window points diagonally into
the room (the arrow in the holder should point upwards).
− Remove the transportation cap from the tamper contact.
− Open the detector cover (by pressing the sides along the window).
− Connect the batteries (leave the internal switches in the 1 STANDARD and 2 DELAY
positions).
− Close the detector and push it on to the holder.
− Wait until the indicator light turns off (calibration is completed) and test whether
the detector reacts to human movement.
− Detected motion is indicated with flashing. You can test for 5 minutes and then
the indicator light turns off. You can repeat the test by opening and closing the detector
housing.
Tips and specifications
*) The detector must have an unrestricted view of the room. To avoid false alarms:
The detector must not be located opposite radiators or other sources of heat with curtains

hanging above them.
It should not be aimed at the windows.

It must not be located near open windows, doors or ventilators (it can react to draughts).

There must not be any things or animals with a temperature around 36 °C (pets, rodents, warm

air from electric appliances, radiator grilles, etc.) in the guarded area.
MLO51206 - 8 -