Using Dump Mode In Ipl - Intermec PB50 User Manual

PB50 and PB51 Mobile Printer User's Guide
Chapter 3 — Troubleshooting and Maintaining the Mobile Printer
Printable characters are printed in black-on-white. Control characters
and space characters (ASCII 000 to 032 dec) are printed in white-on-
black.
As long as a continuous string of characters is being received, the
program wraps the lines until the label is full and then starts to print
another label. After each character transmission, the following
information prints:
Page number
•
• Number of characters printed on the label
• Total number of characters received so far
When you exit Dump mode, a final label prints to inform you that it is
exiting from Dump mode.

Using Dump Mode in IPL

When you enter Dump mode, the printer captures incoming
characters on the communication ports and prints them on one or
more labels.
If you have IPL firmware on your printer, you can access Dump mode
in two different ways with slightly different results:
• You can access Dump mode through Test mode or Extended Test
mode and you will receive printouts that look exactly like those
produced with the Line Analyzer program in Fingerprint. For
more information, see the previous procedure,
Analyzer in Fingerprint" on page
• You can access Dump mode using the control panel buttons. If
you access Dump mode this way, characters are printed on a
continuous line along with corresponding hexadecimal numbers.
To enter Dump mode using the control panel buttons
• Press and hold the Feed and Standby buttons until the printer
starts feeding out media.
The printer feeds out several labels (or inches of media), prints the test
labels, and then enters Dump mode.
To exit Dump mode using the control panel buttons
• Press the Feed button.
"Using the Line
58.
59