Intermec PB50 User Manual page 27

PB50 and PB51 Mobile Printer User's Guide
3 Feed the label liner over the self-strip bar and out the back of the
self-strip door.
4 Remove a label from the roll of media so that you are left with
several inches of label liner.
5 Close the media cover until it latches and press down on the self-
strip door to make sure it locks.
6 Pull on the liner to tighten it and ensure a good self strip.
7 Press and hold the Feed button for more than two seconds to
calibrate the media.
Chapter 1 — Using the Mobile Printer
15