Every 3000 Service Hours; Checking Injection Pump; Annual Servicing; Electrical Wiring And Fuses - Kubota K008-3 Operator's Manual

EVERY 3000 SERVICE HOURS

BChecking Injection Pump
Consult your local KUBOTA Dealer for this
service.

ANNUAL SERVICING

BElectrical Wiring and Fuses
Check the terminals periodically for proper
connections. Loose wiring or damaged cables
can cause improper functioning of the electrical
system. Short circuiting, electrical leaks and
other expensive problems could arise. Check
wiring and replace damaged components
immediately. If a fuse blows out soon after
having been replaced, contact your nearest
KUBOTA dealer. Never use a fuse other than
specified.

BIENNIAL SERVICING

To avoid personal injury:
A Do not loosen the radiator cap before
the radiator
sufficiently. Then only loosen the cap
and allow enough time for the
pressure in the system to be released.
Now remove the cap completely.
BReplacement of Radiator Hoses
Replace radiator hoses and hose clamps ever
two years. If the hoses are swollen, hard or
cracked, they must be replaced earlier.
(1) Radiator hoses
(2) Hose clamps
REGULAR CHECKS AND MAINTENANCE WORK
has cooled down
BChanging Radiator Coolant
(In case of long-life coolant fluid)
Stop the engine and wait until it has cooled
down completely.
1. Open the drain plugs on the bottom of the
radiator and drain coolant completely.
2. To clean, rinse the radiator with water.
3. Close the drain plug and fill the radiator with
coolant fluid. Let the engine idle for about 5
min., stop the engine and check the coolant
level.
4. The machine has been shipped filled with
50% anti-freeze solution.
(1) Drain plugs
(1) Radiator cap
(2) Reserve tank
Radiator
Reserve tank
49
approx. 0.61 gal.
(2.3 L)
approx. 0.13 gal.
(0.5 L)