Lifting Capacity - Kubota K008-3 Operator's Manual

62

LIFTING CAPACITY

LIFTING CAPACITY
1. The lifting capacities are based on ISO 10567 and do not exceed 75% of the static tilt load of the
machine or 87% of the hydraulic lifting capacity of the machine.
2. The strokes are as follows.
(1) The load point corresponds to the front bolt part of the arm.
(2) The machine positions are (i) over-front (Blade up), (ii) over-front (Blade down), and (iii) over-
side.
(3) The operating cylinder is the boom cylinder.
3. The bucket of the excavator, the hook, the sling and other lifting accessories are taken into
consideration for the loads.
Machine conditions:
No bucket, all others according to standard regulations.
To avoid personal injury or death:
A It is forbidden to lift loads greater than those values mentioned in the lifting capacity
tables.
A The values mentioned in the table are valid only on even, hard ground. When lifting on
soft ground, the machine 'can tilt over due to the fact that the load is concentrated only
on one side of the machine.
The table values are calculated at the end of the arm without the bucket. In order to find
the allowable loads for machines with bucket, the bucket weight must be subtracted from
the values in the table.