Thermo Scientific Orion Dual Star User Manual page 69

Thermo Scientific
Temperature – Press the ▲ / ▼ keys to highlight Temperature and press the f2 (select)
•
key. Press the ▲ / ▼ keys to highlight ATC1 or ATC2 as the temperature source of the
ATC probe that will be used on the autosampler and press the f2 (accept) key.
Tray Size – Press the ▲ / ▼ keys to highlight Tray Size and press the f2 (select) key.
•
Press the ▲ / ▼ keys to highlight 28 or 48 as the size of the tray that will be used on the
autosampler and press the f2 (accept) key.
Rinse Beakers – Press the ▲ / ▼ keys to highlight Rinse Beakers and press the
•
f2 (select) key. Press the ▲ / ▼ keys to highlight 0, 1, 2 or 3 as the number of the rinse
beakers that will be used on the autosampler and press the f2 (accept) key.
Rinse Time – Press the ▲ / ▼ keys to highlight Rinse Time and press the f2 (select) key.
•
Use the numeric keypad to enter the time (in seconds) that the electrodes will be rinsed in
each rinse beaker and press the f2 (accept) key. The rinse time can be set from 1 to 59
seconds.
Stirrer Speed – Press the ▲ / ▼ keys to highlight Stirrer Speed and press the f2 (select)
•
key. Press the ▲ / ▼ keys to highlight Off, 1, 2, 3, 4 or 5 as the stirrer speed of the stirrer
probe and press the f2 (accept) key.
Samples – Press the ▲ / ▼ keys to highlight Samples and press the f2 (select) key.
•
o To enter the number of samples that will be run on the autosampler, press the ▲ / ▼
keys to highlight Number of Samples and press the f2 (accept) key. Use the numeric
keypad to enter the number of samples and press the f2 (accept) key.
o To set the sample ID, press the ▲ / ▼ keys to highlight Sample ID and press the
f2 (accept) key. Press the ▲ / ▼ keys to highlight Off, Manual or Auto Incremental
and press the f2 (accept) key. If Auto Incremental is selected, use the alphanumeric
keypad to enter the initial sample ID and then press the f2 (accept) key. Refer to the
meter pullout guide for the location of the letter keys on the numeric keypad. The
meter will save the entered sample ID and add a sequential number after it.
o Once all of the sample settings are entered, press the f1 (back) key.
Once all of the autosampler settings are entered, press the f1 (back) key.
•
Autosampler Operation
Orion Dual Star pH/ISE Benchtop Meter User Manual
Section 8
|
69
|