Thermo Scientific Orion Dual Star User Manual page 21

Thermo Scientific
connected to the meter and enabled in the setup menu. If Timed Reading is
selected, enter the time delay value in a minutes : seconds format using the
numeric keypad and press the f2 (accept) key.
4. Repeat step 3 for channel 2.
5. Press the ▲ / ▼ keys to highlight Printer, Computer or None as where the meter will
export the measurement and calibration data and press the f2 (accept) key. If Printer or
Computer is selected, the meter will prompt the operator to set the baud rate. Press the
▲ / ▼ keys to highlight 1200, 2400, 4800, 9600, 19200 or 38400 as the baud rate and
press the f2 (accept) key.
6. Press the f2 (yes) key to enable the exporting of the measurement data to the data log or
press the f3 (no) key to disable the exporting of the measurement data to the data log.
7. Press the f2 (measure) key to save the EZ Startup menu settings and proceed to the
measurement mode or press the f1 (back) key to edit any of the EZ Startup settings.
Meter Setup
Orion Dual Star pH/ISE Benchtop Meter User Manual
Section 3
|
21
|