Thermo Scientific Orion Dual Star User Manual page 27

Thermo Scientific
to a printer or computer, if a printer or computer is connected to the meter and enabled in
the setup menu. If Timed Reading is selected, enter the time delay value in a minutes :
seconds format using the numeric keypad and press the f2 (accept) key.
Alarm
Press the ▲ / ▼ keys to highlight Alarm and press the f2 (select) key. View and change the
alarm settings, if required.
Alarm – Press the ▲ / ▼ keys to highlight Alarm and press the f2 (select) key. Press the
•
▲ / ▼ keys to highlight Off, Low Limit, High Limit or Both Low/High and press the
f2 (select) key.
Parameter – Press the ▲ / ▼ keys to highlight Parameter and press the f2 (select) key.
•
Press the ▲ / ▼ keys to highlight pH, ISE-ppm, ISE-mg/L, ISE-%, ISE-M, ISE-unitless,
mV, RmV, ORP or °C (°F will be shown instead of °C if it is the selected temperature unit)
and press the f2 (accept) key.
Low Limit – Press the ▲ / ▼ keys to highlight Low Limit and press the f2 (select) key. To
•
enter a low limit alarm value, use the numeric keypad and decimal key to enter the low
value and press the f2 (accept) key.
High Limit – Press the ▲ / ▼ keys to highlight High Limit and press the f2 (select) key. To
•
enter a high limit alarm value, use the numeric keypad and decimal key to enter the high
value and press the f2 (accept) key.
Note: The read type must be set to continuous to use the alarm settings.
Sample ID
Press the ▲ / ▼ keys to highlight Sample ID and press the f2 (select) key. Press the ▲ / ▼
keys to highlight Off, Manual or Auto Incremental and press the f2 (accept) key. If Auto
Incremental is selected, use the alphanumeric keypad to enter the initial sample ID and press
the f2 (accept) key. The meter will save the entered sample ID and add a sequential number
after it.
Method
Press the ▲ / ▼ keys to highlight Method and press the f2 (select) key. Press the ▲ / ▼ keys
to highlight the desired method number, press the f2 (load) key and press the f2 (yes) key. To
view a method, edit a method, copy an existing method to a new method, delete a method, print
a method or save the current meter settings as a new method, refer to Chapter 5 Methods.
Meter Setup
Orion Dual Star pH/ISE Benchtop Meter User Manual
Section 3
|
27
|