Setting The Self Clean Mode - Panasonic HL-BD82S Service Manual

HL-BD82S
5.9.

Setting the Self Clean Mode

5.9.1. To set the Self Clean Mode
1. Rotate both knobs into the clean position.
2. CLEAN & TIME appear.
3. The clean time is displayed automatically, its standard
value is 3 hours.
4. At the end of the programmed cleaning time, the oven will
automatically turn off.
5. To stop the cleaning mode at any moment, move one of
the two knobs from the cleaning position.
Do not attempt to open the door while the door is locked. The
[AUTO LOCK] writings will flash until the motor stops. When
they are displayed, the door cannot be opened. Check that the
door has been locked and will not open before starting the Self-
Clean mode.
If door does not lock, rotate the cooking mode knob into the
OFF position and do not start self-clean; phone for service.
If the door is in the open position when this mode is selected,
the [AUTO LOCK] writings will flash until the door is closed. The
latch doesn't move.
5.9.2. To change the Clean Time
1. To change the setting from 3 hours, select either 2 hours
for light soil or 4 hours for heavy soil immediately before
starting.
2. To change the hours, touch the [TIME]
3. The hours will flash.
4. Use [INC] or [DEC]
5. To change the minutes, touch the [TIME]
6. The minutes will flash.
7. Use [INC] or [DEC]
Hold the key to change by 10 minutes steps.
8. Touch [TIME] or wait a few seconds to confirm the
new value.
key.
keys to change the value.
key again.
keys to change the value.
5.9.3. To Delay the Start of Clean
1. Follow steps 1 through 7 above.
2. Touch the [TIME]
appears on the display. The hours will begin flashing.
3. Use [INC] or [DEC]
value.
4. To change the minutes, touch the [TIME]
minutes will flash.
5. Use [INC] or [DEC]
Hold the key to change by 10 minutes steps.
6. Touch [TIME]
new value.
7. The latch starts moving to lock the oven door, the display
shows [DELAY].
8. When the delay time expires, self-cleaning will start.
9. At the end of the programmed cleaning time, the oven will
automatically turn off.
10. [End] will appear on the temperature display, [CLEAN] on
the mode display and [TIME] on the clock display will start
flashing until the [TIME]
moved to the OFF position.
In order to check the cleaning or the stop time during a delayed
clean, simply touch the [TIME]
[STOP TIME] writings are displayed.
12
key and verify that [STOP TIME]
keys to change the stop time
keys to change the value.
or wait a few seconds to confirm the
key is touched or the knob is
key until [TIME] or
key, the