Panasonic HL-BD82S Service Manual page 27

7.16. Power board replacement
1. Disconnect the power supply cord and remove the Oven
from the cabinet.
2. Remove the upper cover.
3. Remove the screws connecting the power board before
disconnecting the cables.
4. Replace the new power board using the spacers.
5. Connect the cable following the electric diagram.
6. IT IS VERY IMPORTANT TO CONNECT THE CABLES
IN THE RIGHT POSITION.
7. The connections must not be loose.
8. Reconnect the power supply cord before installing the
Oven and check all functions.
9. Disconnect the power supply cord and reinstall the Oven
into the cabinet.
10. Reconnect the power supply cord after installing.
11. Run the Oven and check all functions.
7.17. Temperature or Function
Selectors replacement
1. Disconnect the power supply cord and remove the Oven
from the cabinet.
2. Remove the upper cover.
3. Remove the knobs and the glass by its screws on the
sides.
4. Disconnect the bad selector and remove it by the screws
remove also its spacer.
5. Replace the new selector by reversing the previous steps
6. DURING MOUNTING, THE SPRING BUTTONS MUST
BE IN THE RIGHT POSITION.
7. Reinstall the Oven into the cabinet.
8. Reconnect the power supply cord after the Oven is
installed.
9. Run the Oven and check all functions
7.18. Display Board replacement
1. Disconnect the power supply cord and remove the Oven
from the cabinet.
2. Remove the upper cover.
3. Remove the knobs and the glass by its screws on the
sides.
4. Before to remove one of lateral display remove previ-
ously the selector above it to facilitate the operation.
5. Disconnect the bad display board and remove it by the
nylon spacers.
6. Reinstall the Oven into the cabinet.
7. Reconnect the power supply cord after the Oven is
installed.
8. Check the Oven by MANUAL TEST following the pro-
cedure shown on section 5.12.Configuration.
7.19. Door external glass replace-
ment
1. Remove the door from the oven (see section 5.10.Oven
Door Removal).
2. Put the door on a flat surface with a soft cloth to prevent
scratching of the aesthetics.
3. Remove the external glass from the door unscrewing two
screws on the corner A and three screws on the bottom
B.
4. Remove also the handle by its two screws C.
5. Replace the handle on the new aesthetic glass with its
support and spacers. Than fixing the spring clip on metal
supports glass.
27
HL-BD82S