Door Gasket Replacement - Panasonic HL-BD82S Service Manual

HL-BD82S
7.6. Lower element replacement
1. Disconnect the power supply cord and remove the Oven
from the cabinet.
2. Remove the rear cover.
3. Disconnect the terminals of heating element.
4. Remove the eight screws B on the brackets and the other
two screws A near the external terminals.
5. Remove the brackets.
6. Pull out the lower element.
7. Replace the new element by reversing the previous
steps.
8. Pay attention to the positioning of the element.
9. Connect the terminals.
10. The connections must not be loose.
11. Reinstall the Oven into the cabinet.
12. Reconnect the power supply cord after the Oven is
installed.
13. Run the Oven and check all functions.
7.7. Lock door motor replacement
1. Disconnect the power supply cord and remove the Oven
from the cabinet.
2. On Single oven remove the two upper covers.
3. Disconnect the cables. Pay attention to the sequence of
wiring of the motor (micro switch).
4. Remove the screws A and lift back the motor to remove it.
5. Disassemble the motor by removing the three screws
under its support and remove it.
6. Replace the new motor assembly by reversing the previ-
ous steps.
7. Pay attention to the positioning when inserting the door
lever mechanism into the eccentric of the motor.
8. Connect the terminals.
9. The connections must not be loose.
10. Reinstall the Oven into the cabinet.
11. Reconnect the power supply cord after the Oven is
installed.
12. Run the Oven and check all functions.
7.8.

Door Gasket replacement

1. Open door and pull out the gasket by hands.
2. Replace with a new one by reversing the previous steps.
24