How To Replace Water Level Sensor - Sanyo MCO-18AIC Service Manual

HOW TO REPLACE WATER LEVEL SENSOR.

1.Unplug the unit and check that power is not supplied
to the unit, then take the rear cover off.
2.Unfasten the connectors for lead wire and take out the
insulation for the lead wire hole.
3.Take out the duct from inside.
4.Unfasten the 2 screws to remove unit of water level
sensor and installation grommets for water level
sensor.
5.replace water level sensor.
Note Be sure to set the water level sensor to the
right direction.
6.Place back the water level sensor, Water sensor
installation grommet as before.
7.Place back the insulation material to the hole for
the lead wire.
Note Be careful for the length of lead wire for
water level sensor inside the unit Length is
nd
connect 2 binder is located where it touches
the water level sensor grommet.
(refer to Fig.3)
3.Put the rear cover in place
Water level sensor
lead wire connector
Insulation for the
lead wire hole
40
Fig.1
screw
Water level sensor
Installation grommet
Water level sensor
Fig.2
Water level
Sensor grommet
Fig.3
binder