Stacked Module - Sanyo MCO-18AIC Service Manual

STACKED MODULE

This unit can be stacked by using the stacking kit. Following shows the procedure for stacking the unit.
Consult with a Sanyo representative or agent prior to stacking procedure as such work involves dangers.
WARNING
Select a level and sturdy floor having enough strength for installation of stacked module.
Never stack 3 or more units.
Take care not to drop or tip over the unit when stacking as this can cause injury or damage of the
unit.
1. Turn off the power switch and disconnect a plug of each unit.
2. The stacking plate A and B are attached on the back of each unit. To prepare the stacking plate A
and B, remove the rear cover by unscrewing 6 screws on the rear cover. See the figure below.
3. Take out the stacking plate A and B by loosening 2 fixing screws on each unit.
4. Replace the rear cover and fix it with 6 screws.
5. Check that the lower unit is level.
Stacking plate B
Stacking plate A
Fixing screws
Rear cover
Note:
When stacking the unit, 2 stacking plates A and 2 stacking plates B are necessary. Each unit has 1
stacking plate A and 1 stacking plate B attached to the back. Remove stacking plate A and B from back
of each unit.
79
33