Installation; Installation Site - Sanyo MCO-18AIC Service Manual

INSTALLATION

Installation site

To operate this unit properly and to obtain maximum performance, install the unit in a location with the
following conditions:
Note: The ambient temperature must be at least 5
1. A location not subjected to direct sunlight or direct air flow from an air conditioner
2. A location with clean air and adequate ventilation (Small and sealed room is not recommended.)
WARNING
If the unit is used in a small confined room, the CO
harmful to humans.
Ventilate a room air occasionally when using CO
an enclosed small room and high level of gas density can be hazardous to health. In addition, avoid
inhaling the chamber air directly when opening the door if CO
3. A location away from heat generating sources
4. A location with a sturdy and level floor
WARNING
Install the unit on a sturdy floor. If the floor is not strong enough or the installation site is not
adequate, this may result in injury from the unit falling or tipping over.
Select a level and sturdy floor for installation. This precaution will prevent the unit from tipping.
Improper installation may result in water spillage or injury from the unit tipping over.
5. A location without flammable or corrosive gas
WARNING
Never install the unit in a flammable or volatile location. This may cause explosion or fire.
Never install the unit where acid or corrosive gases are present as current leakage or electric shock
may result due to corrosion.
6. A location not prone to high humidity
WARNING
Do not use the unit outdoors. Current leakage or electric shock may result if the unit is exposed to
rain water.
Never install the unit in a humid place or a place where it is likely to be splashed by water.
Deterioration of the insulation may result which could cause current leakage or electric shock.
14
o
C lower than the set temperature.
density level in the air could rise and may be
2
gas for control. The gas density will increase in
2
gas is used.
2
60