Mco-21Sb Setting Procedure - Sanyo MCO-18AIC Service Manual

MCO-21SB Setting Procedure

(Stacking base for stacking MCO-18AIC/17AIC/17AC/15AC on MCO-20AIC)
1. Stick the " Buffer rubber" at each corner on the bottom of "
Stick the " Protective sticker" on the "
2. Attach the" Base mounting plate" onto the top of MCO-20AIC by using "
3. Remove 2 hooks on the rear side of MCO-20AIC.
4. Fix the " Stacking base" onto the top of MCO-20AIC by using "
removed in step 3.
5. In case of stack MCO-18AIC
Put the upper unit on it. Fix the upper unit with "
( Rear fixing plate R and
In case of stack MCO-17AIC/17AC/15AC
Put the upper unit on it. Fix the upper unit with "
" Rear fixing plate L". (
6. Check the both units are level.
Fig.1
Fig.2
Stacking base" as shown in Fig.1.
Front fixing plate", "
Rear fixing plate L are not used.)
Front fixing plate", "
Rear fixing plate is not used.)
No.
Stacking base
Base mounting plate
Front fixing plate
Rear fixing plate R (for 17AIC/17AC/15AC)
Rear fixing plate L (for 17AIC/17AC/15AC)
Rear fixing plate (for 18AIC)
Protective sticker
Buffer rubber
Fixing screw A
Fixing screw B
hook
44
Stacking base".
Fixing screw B".
Fixing screw A" and 2 screws
Rear fixing plate ".
Rear fixing plate R", and
Parts name
Fig.3
Q'ty
1
1
2
1
1
2
2
4
2
10
( )
( )
7FB 6 P104 040 00 0