Mco-18Sb Setting Procedure - Sanyo MCO-18AIC Service Manual

MCO-18SB Setting Procedure

(Stacking base for stacking MCO-18AIC/17AIC/17AC/15AC on MCO-175/175M)
1.Remove four clips on the top of lower unit.
2.Fasten four " Fixing screws A" tentatively from where the clips were remove.
3.Set the " Stacking base" and fix with screws tentatively fastened.
4.Stick the " Protective sticker" on the "
5.In case of stack MCO-18AIC
Put the upper unit on it. Fix the upper unit with "
( Rear fixing plate R and
In case of stack MCO-17AIC/17AC/15AC
Put the upper unit on it. Fix the upper unit with "
" Rear fixing plate L". (
6.Check the both units are level.
Fig.1
Stacking base" as shown in Fig.1.
Rear fixing plate L are not used.)
Rear fixing plate is not used.)
NO.
Stacking base
Front fixing plate
Rear fixing plate R (for 17AIC/17AC/15AC)
Rear fixing plate L (for 17AIC/17AC/15AC)
Rear fixing plate (for 18AIC)
Protective sticker
Fixing screw A
Fixing screw B
43
Front fixing plate", " Rear fixing plate ".
Front fixing plate", "
Parts name
Fig.2
Rear fixing plate R", and
Q'ty
1
2
1
1
2
2
4
8
( )
( )
7FB 6 P104 041 00 0