Sanyo MCO-18AIC Service Manual page 83

STACKED MODULE
6. Apply the protective sticker enclosed with the unit at each corner on the top of the lower unit to avoid
scratches or damage.
7. Fix the stacking plate A at 2 locations on the top front of the lower unit by using 2 screws removed in
step 3.
8. Remove the front panel on the upper unit by unscrewing the 4 fixing screws and then disconnect the
wires and gas tube.
9. Stack the unit so that both units can be aligned straight. Also check the upper unit is level. If it is not
level, keep the unit even by adjusting the leveling legs.
10. Secure the upper unit with the stacking plate A and 2 screws removed in step 3.
11. Remove 2 hooks on the rear side of the lower unit by unscrewing each 2 fixing screws.
12. Remove 1 screw on the bottom right and left on the rear side of the upper unit.
13. Fix the stacking plate B at the right and left on the rear of the lower and upper unit with 3 screws
removed in step 11 and 12.
14. Replace the front panel on the upper unit after connecting the wires and gas tube.
15. Fix the stacked unit to the wall with 2 hooks on the rear of the upper unit and rope or chain.
Front panel
Stacking plate B
Stacking plate A
Hook
Protective sticker
80
34