How To Replace Water Sensor - Sanyo MCO-5M Service Manual

How to replace water sensor

1. Unplug the unit and ensure the power is not
supplied, then take the rear cover off.
2. Unfasten the connectors for lead wire and take out
the insulation for the lead wire hole.
3. Take the duct out.
4. Unfasten the 2 screws that fixed water sensor and
grommet.
5. Replace water sensor.
Note Ensure water sensor should be placed correctly
that its sensing area should be faced to the right.
(See Fig.3)
6. Fix water sensor and grommet back to original position.
7. Place the insulation to the hole for the lead wire and
connect lead wire.
Note Ensure the length of lead wire for water sensor
should be positioned correctly.
(See Fig.4)
3.Put the rear cover back.
Screw
Fig.3 (front view)
50
Fig.1
Grommet for
Water sensor
Water sensor
Fig.2
Sensing area
Fig.4