Red Flashing
= No Fiber Link from RX to TX (Not available in Local Static mode).
For VEL-6 models, there is no LED indication for Fiber L3. In single-link mode, video is not affected if L3
is not connected. In dual-link mode, there will be no video if L3 is not connected.
• RX Status LED
The status LED indicates the connection status of the RX Extender.
Green
= Good Link and DVI monitor connected to primary port (port on left looking at DVI connectors).
Orange
= No DVI monitor connected to primary port.
Red Flashing
= No Fiber Link from TX to RX (L1 is not connected).
• Power LED
When lit, the
Green LED
• Grounding Stud
A grounding stud located below the power jack allows the unit to be hard-wired to electrical ground if
required.
5. Regulatory and Safety Compliance
5.1. Symbols Found on Our Products
Markings and labels on our products follow industry-standard conventions. Regulatory markings
found on our products comply with all domestic and many international requirements.
5.1.1. Class 1 Laser Labeling
The DVI Extender models VEL-3, -6, -33 and -63 are designed and identified as Class 1 LASER
products.
5.2.
Regulatory Compliance
Thinklogical VelocityDVI Extender products are designed and made in the USA. VelocityDVI Extender
products have been tested by a nationally recognized testing laboratory and found to be
compliant with the following standards (both domestic USA and many international locations).
5.2.1. North America
These products comply with the following standards:
Safety
ANSI/UL60950-1: 1
•
CAN/CSA C22.2 No. 60950-1-03
•
Laser Safety
CDRH 21 CFR 1040.10
•
Class 1 Laser Product: VEL-3, VEL-6, VEL-33, VEL-63
•
Accession Number TBD
•
Electromagnetic Interference
FCC CFR47, Part 15, Class A
•
Industry Canada ICES-003 Issue 2, Revision 1
•
V e l o c i t y D V I E x t e n d e r P r o d u c t M a n u a l , R e v . G , M a y ,
near the power jack indicates that +5VDC power is applied to the unit.
st
Edition (2003)
Page 34
2 0 1 3