Advertisement
G
A
B
D
E
A - Digit height 14mm (1000), 10mm (1001), 20mm (1101) green
Value of variable controlled to 3 digits (1000) 3
Indication - 199...+999 (1000) indication -999...+1999 (1001-1101) with decimal point on appropriate scales.
Positive (HI) or negative (LO) off-scale message Message for broken/incorrect connection of probe; (SBR: open circuit /
ERR: probe reversed) and display of configuration and calibration messages.
B - Digit height 14mm (1000), 10mm (1001), 14mm (1101) green. Setpoint value.
Alarm limit range -199...+999 (1000) -999...+1999 (1001-1101).
IAlarm limits are accompanied by flashing of AL 1 AL2 AL3/HB LEDs.
Main output value in percentage(0...99%) followed by letter P. Parameter values and configuration data.
C - Function key
Accesses setpoint and alarm functions (each function is specified by flashing of LED for reading and/or changing of values.
If the F key is not pressed to confirm a change, saving is done automatically after 10 sec. and the display returns to setpoint
value.
The F key accesses the various configuration and saving procedures for changed settings.
D - Raise Key / E - Lower Key
These keys raise or lower the value of the displayed function.
The raising (lowering) speed is proportional to the time the key is pushed.
The procedure is not cyclical. When the maximum (minimum) of the setting range is reached with the key pushed, the raise
(lower) function stops.
F - Main output on. Green LED
G - Alarm signal. Red LED
Faceplate protection IP54 (IP65 available)
80343I_MHW_1000_07-2011_ENG
3 • DESCRIPTION OF FACEPLATE
F
A
B
C
D
E
digits (1001 -1101)
1/2
G
F
C
G
A
B
D
F
E
C
3
Advertisement
