gefran 1200-RD00-00-0 Series Quick Start Manual

Quick Start Guide
1200-RD00-00-0-x Programmable PID Controller
GETTING STARTED
• Unpack Contents
• Verify model numberand application
• Power Controller
• Program for yourapplication
Note
Change all menu parameters by
using the front panel buttons
1
What's Included
• 48x96 DIN 1200-RD00-00-0-x
Gefran Controller x2
• Mounting Bracket
• Panel Sealing Gasket
• Screw Terminal Cover
• Multi-Language Manual
2
Program Your Gefran Controller
• Press and hold until PAS appears — ENTER 99
F
• Press F once, Pro appears — ENTER 128
• Press F once, PAS appears — ENTER 99
• Press and hold until Hrd appears
F
• Press repeatedly until but appears — ENTER 1
F
until1 nP appears
• Press and hold
F
• Press F twice, tYP appears — ENTER the Input Sensor number
from the list
• Press repeatedly until Lo.S* appears — ENTER the minimum Input Scale limit
F
once, H i.S* appears — ENTER the maximum Input Scale limit
• Press
F
• Press repeatedly until Lo.L* appears — ENTER the minimum Alarm Scale limit
F
once, H i.L* appears — ENTER the maximum Alarm Scale limit
• Press F
• Press and hold F until you return to the main process display. This is the display after PAS
and will be indicated by the Process Variable if an input sensor is connected, or Lo, H i, Sbr,
Err if no input is connected.
• Use the and buttons to adjust the control setpoint (SV) from the main display.
• Press once from the main display, AL.1 appears to adjust the Alarm 1 setpoint.
F
• Press the button to switch between automatic and manual control modes from the
main display. LED 1( ) will light while in manual mode.
L1
* Parameter may be left at default value for input types 0...37
Input Sensor
Sensor Type Sensor Type
0 TC J °C 30 PT100 °C
1 TC J °F 31 PT100 °F
2 TC K °C 32 JPT100 °C
3 TC K °F 33 JPT100 °F
4 TC R °C 34 PTC °C
5 TC R °F 35 PTC °F
6 TC S °C 36 NTC °C
7 TC S °F 37 NTC °F
8 TC T °C 44 4...20 mA
9 TC T °F 46 0...10 V
Via Sebina, 74 - 25050 PROVAGLIO D'ISEO (BS) ITALY
Heat & Alarm
3
Connect Your Controller
8
Additional wiring
configurations
are available
in the User's
7
Manual and
General Setup
Guide
6
5
11 2
10 1
POWER
If needed, automatic tuning (Self-Tune) can be enabled
with the following steps
With the machine at ambient temperature and
the control setpoint (SV) set...
• Press and hold until CFG appears
F
• Press once, S.Tu appears — ENTER 2
F
• Press once
F
• Cycle power to the controller
• LED 3 ( ) will flash during the tuning process
L3
Self-Tune will automatically save new PID
values once complete
This Quick Start Guide provides basic information on
setting up the Gefran 1200 controller for the application
referenced above. Additional software and hardware
configuration information can be found in the User's Manual
included with this controller or online at www.gefran.com
GEFRAN SpA
ALARM
-
+
HEATER
POWER CONTROL
-
+
THERMOCOUPLE