Briggs & Stratton 1696614-00 Operator's Manual page 14

Hex Shaft and Gear Lubrication
NOTICE: Do not allow grease or oil to contact the rubber
friction wheel or the disc drive plate. If grease or oil comes
into contact with the friction wheel, replace it. Do not attempt
to clean it. If grease or oil comes into contact with disc drive
plate, clean it thoroughly with an alcohol based solvent.
1. Position speed select lever in the first forward gear.
2. Drain fuel to an approved container.
WARNING
Fire and explosion hazard
·ÉÅ¿Ļ ¿É ¾¿½¾ÂÏ ¼Â·Ã÷¸Â» ·Äº ¿ÊÉ Ì·ÆÅÈÉ ·È» »ÎÆÂÅÉ¿Ì»
Drain gasoline outdoors, away from fire and other ignition
sources. Wipe up any spills immediately. Do NOT allow
open flame, smoking, or matches in the area.
3. Stand the snowthrower up on the auger housing end.
NOTE: When the crankcase is filled with oil, do not leave
the snowthrower standing up on the auger housing for an
»Îʻĺ»º ƻȿź ż ʿû
4. Remove screws (A, Figure 9) and bottom panel (B).
¿Æ» ʾ» ¾»Î ɾ·¼Ê
motor oil, before storage and at the beginning of each
season.
6. Install the bottom panel (B, Figure 9) and screws (A).
14
¿½ËÈ» Ϳʾ  ÉÏÄʾ»Ê¿¹
9
A
10
A
A
C
B