Inbound Services - Sitecom WL-108 Full Manual

WL-108 Wireless Network Modem/router 11M
Data – Incoming Rules Screen

Inbound Services

Select the desired Service. This determines which packets are covered
Service
by this rule. If necessary, you can define a new Service on the
"Services" screen, by defining the protocols and port numbers used by
the Service.
Select the desired action for packets covered by this rule:
Action
•
•
•
•
Note:
•
•
•
Select the PC or Server on your LAN which will receive the inbound
Send to
traffic covered by this rule.
LAN Server
These settings determine which packets are covered by the rule, based
WAN Users
on their source (WAN) IP address. Select the desired option:
•
•
•
This determines whether packets covered by this rule are logged. Select
Log
the desired action.
•
•
•
•
ALLOW always
ALLOW by schedule, otherwise Block
BLOCK always
BLOCK by schedule, otherwise Allow
Any inbound traffic which is not allowed by rules you create will be
blocked by the Default rule.
BLOCK rules are only useful if the traffic is already covered by an
ALLOW rule. (That is, you wish to block a sub-set of traffic which is
currently allowed by another rule.)
To define the Schedule used in these selections, use the "Schedule"
screen.
Any - All IP addresses are covered by this rule.
Address range - If this option is selected, you must enter the
desired values in the "Single/Start" and "Finish" fields to determine
the address range.
Single address - Enter the required address in the "Single/Start"
fields.
Always - always log traffic considered by this rule, whether it
matches or not. (This is useful when debugging your rules.)
Never - never log traffic considered by this rule, whether it
matches or not.
Match - Log traffic only it matches this rule. (The action is
determined by this rule.)
Not Match - Log traffic which is considered by this rule, but does
not match (The action is NOT determined by this rule.)
55