Client Configuration; Overview; Configuring The System; Modbus Register Maps - ABB FENA-01 Protocol Manual

Protocol manual - modbus/tcp ethernet adapter module

Hide thumbs Also See for FENA-01:

Table of Contents

Client configuration

This chapter gives information on configuring the Modbus/TCP

client for communication through the FENA-01 Ethernet Adapter

module.

After the FENA-01 Ethernet Adapter module has been

mechanically and electrically installed according to the instructions

in the FENA-01 Hardware Manual and has been initialized by the

drive, the client must be prepared for communication with the

module.

Please refer to the client documentation for information on

configuring the system for communication with the FENA-01.

The Modbus register map presented by the FENA-01 to the

Modbus client is selected by the PROFILE configuration

parameter. For details, see chapter

For Modbus register map definitions, see chapter Communication.

For definitions of Control, Status, References and Actuals for a

given communication profile, see chapter

Drive

configuration.

Communication

Client configuration

profiles.

Table of Contents