Proceq hygropin Operating Instructions Manual page 8

Submenu Probe Settings
Calculated Parameters
The Hygropin can calculate any of the following psychrometric parameters based on humidity and
temperature:
• Dew point (Dp) above and below freezing
• Frost point (Fp) below freezing and dew point above freezing
• Wet bulb temperature (Tw)
• Enthalpy (H)
• Vapor concentration (Dv)
• Specific humidity (Q)
• Mixing ratio by weight (R)
• Vapor concentration at saturation (Dvs)
• Vapor partial pressure (E)
• Vapor saturation pressure (Ew)
Any of the above parameters can be set in the submenu "Probe Setting".
Calculating some of these parameters requires barometric pressure as an input parameter. A fix
barometric pressure value can be specified in the "Device Settings" Menu.
Probe Menu
© by Proceq SA
Probe Type
Calculation (digital
only)
Output Voltage (analog probe)
...
Measuring Range
probe)
...
Submenu detail information digital probe
Submenu Humidity Adjustment
Submenu Temperature Adjustment
These functions are for service and calibration purpose only.
HygroClip / Analog / Pressure
probe See "Calculated Parameters"
(analog
8