Hygrolink - Proceq hygropin Operating Instructions Manual

Data Logging
The Hygropin can automatically record up to 10,000 humidity-temperature values measured by a
single probe. Each record is stamped for date and time. The calculated parameter cannot be re-
corded. When recording data from two probes at the same time, the recording capacity per probe
is cut in half.
The Hygropin features two data logging mode: start-stop (recording ends when the memory is full)
and loop (when the memory is full, the oldest record is dumped to make room for a new record)
Data logging can be started and stopped from the keypad. The HygroLink software allows the
downloading of the recorded data for further analysis.
Data Logging
Submenu Settings

4. HygroLink

Installation
To start the installation wizzard of the software & driver package execute HygroLink_Setup.exe on
the included CD ROM.
Remove the red cover cap and connect the USB cable to the connector.
1. Establish connection to Hygropin
2. Download all data from the Hygropin in Excel-Files
3. Delete all data on the Hygropin
4. Disconnect Hygropin
5. Check for updates HygroLink
© by Proceq SA
Status Data logging
No. of sample taken
Status Logging Interval
Status Logging Mode
Start / Stop Recording
Submenu Settings
Interval setting
Logging Mode setting
Logging Probe 1
Logging Probe 2
Cannot be changed while the Hygropin is recording data.
ON / OFF
max. 10'000 H+T
5s...1h
StartStop / Loop
5s..1h
StartStop / Loop
ON / OFF
ON / OFF
10