Protection By Locking The Cpu/Interface Module - Siemens Simatic S7-1500/ET 200MP System Manual

Protection

9.7 Protection by locking the CPU/interface module

Removing copy protection
To remove copy protection, follow these steps:
1. Remove any existing Know-how protection (Page 197).
2. Open the properties of the respective block.
3. Select the "Protection" option under "General".
4. In the "Copy protection" area, select the "No binding" entry from the drop-down list.
Figure 9-8
9.7 Protection by locking the CPU/interface module
Locking options
Protect your CPU/interface module from unauthorized access by additionally using a
sufficiently secured front cover.
You have e.g. the following options:
● Affix a seal
● Secure the front cover with a lock (shackle diameter: 3 mm)
Figure 9-9
202
Removing copy protection
Locking latch using a CPU as an example
Automation system
System Manual, 12/2017, A5E03461182-AE