Assigning Profisafe Address To Fail-Safe Modules With Simatic Safety - Siemens Simatic S7-1500/ET 200MP System Manual

Configuring operation on PROFIBUS DP using a GSD file
If you want to configure the operation on the PROFIBUS DP using GSD file, note the
following additional requirements:
Table 7- 2 Requirements for PROFIBUS DP with GSD file
I/O modules
Input/output modules 35 mm
Input/output modules 25 mm
Technology modules (TM)
Communications modules CM PtP
7.3 Assigning PROFIsafe address to fail-safe modules with SIMATIC
Safety
The PROFIsafe address is saved permanently on the electronic coding element of the
S7-1500/ET 200MP fail-safe modules. You can find additional information on the electronic
coding element in the section Replacing the coding element at the power connector of the
system power supply and load current supply (Page 285).
Note
The supply voltage L+ must be applied to the F-module during the assignment of the
PROFIsafe address (F-destination address together with F-source address).
For additional information on assigning the PROFIsafe address (F-destination address
together with the F-source address), refer to the SIMATIC Safety - Configuring and
Programming (http://support.automation.siemens.com/WW/view/en/54110126) programming
and operating manual and the online help.
Automation system
System Manual, 12/2017, A5E03461182-AE

7.3 Assigning PROFIsafe address to fail-safe modules with SIMATIC Safety

Required firmware version
IM 155-5 DP ST as of ...
V1.0.0
V2.0.0
V2.0.0
V1.0.0
Required firmware version I/O modules
as of ...
V2.0
V1.0
V1.1
V1.0.1
Configuring
177