Dimension Drawing Of Test Probe For Measurement Tap - Siemens Simatic S7-1500/ET 200MP System Manual

Dimension drawings
A.9 Dimension drawing of test probe for measurement tap
A.9

Dimension drawing of test probe for measurement tap

To perform measurements on the front connector of the S7-1500/ET 200MP automation
system, you need a test probe with the following properties:
● Maximum diameter at measuring tip: 1 mm
● Length of measuring tip: ≥ 10 mm
Figure A-15
Corresponding test probes are available from electrical retailers.
334
Dimension drawing of test probe for measurement tap
Automation system
System Manual, 12/2017, A5E03461182-AE