Table of Contents
Advertisement
3
Replacing Assembly Units
8
3.3
Replace the printhead
The printhead of the label printer can be replaced without the need for fine adjustment. The printhead must be
replaced if worn.
1
4
7
Fig.3
Printhead components
Warning!
!
Printhead will be very hot on the print line after printing. Risk of burn. Before you remove the printhead,
wait five minutes after switched off.
Attention!
!
The printhead (7) is adjusted on a head plate (1) and precisely aligned at the factory. Do not loosen the
screws (4) under any circumstances.
Attention!
!
The printhead can be damaged by static electricity discharges and impacts!
Set up printer on a grounded, conductive surface.
Ground your body, e.g. by wearing a grounded wristband.
Do not touch contacts on the plug connections (2, 3).
Do not touch printing line (5) with hard objects or your hands.
2
6
3
5
1 Head plate
2 Plug connector
3 Plug connector
4 Screw
5 Print line
6 Pins
7 Printhead
6
4
8
Advertisement
Table of Contents
