CAB XD4M/300 Service Manual page 12

3 Replacing Assembly Units
12
Installing slipping clutch on tranfer ribbon hub
Fig.9 Slipping clutch on the rewinders
1. Slide coupling (5) onto the winder axis (7).
2. Align grooves in the coupling disks (6) with the guides in the collar of the gear (8).
3. Slide coupling further until it stops.
4. Secure the snap ring (4).
5. Adjust the coupling 
6. Install rear cover.  3.2 on page 7
Installing the brake on the transfer ribbon supply hub
Fig.10 Brake on transfer ribbon supply hub
1. Slide the brake (8) onto the winder axis (2) in such a way that it fits on the hexagonal profile of the carrier (7).
2. Ensure that the lever (9) grasps between the two ends of the spring (6).
3. Secure the snap ring (5).
4. Adjust the coupling  4.1 on page 18.
5. Install rear cover. 3.2 on page 7
1 2 3
4.1 on page 18
6 2 7 9
4 5
1 Collar of the gear
2 Winder axle
3 Coupling disks
4 Slipping clutch
5 Snap ring
8 5
2 Winder axle
5 Snap ring
6 Spring
7 Carrier
9 Lever
8 Brake
5 Snap ring
12