Tub Back, Bearing And Cylinder Assembly; Bearing Housing Assembly - Dexter Laundry T900 Parts & Service Manual

Cylinder (basket)
Step 1: Remove the top panel as described previously.
Step 2: Remove lower service panel as described previously.
Step 3: Remove front panel as described previously.
Step 4: Remove masking ring as described previously.
Step 5: Remove door lock assembly. (Leave wires & pull rod in place)
Step 6: Remove clothes door.
Step 7: Remove tub front clamp ring.
Step 8: Remove tub front. Use a flat screw driver to pry the tub front
loose.
Step 9: Remove the rear access panel.
Step 10: Remove the drive belts.
Step 11: Remove drive pulley. Remove 3 retaining screws. Insert (3) 3/8
16 x 2" screws into the threaded removal holes. Alternately
tighten these screws evenly to pull the pulley off.
Step 12: Remove pulley hub. Drive a flat screw driver into the slot in the
hub and pull it from the shaft.
Step 13: Install cylinder puller. (Snap On part #CJ-84-C) Be sure to thread
a 5/8-11 NC bolt into the end of the cylinder shaft to protect the
threads. Push the basket out.

Bearing Housing Assembly

Removal
Step 1: Remove cylinder from washer (see Cylinder (basket) removal).
Step 2: Remove 6 7/16" tub back to bearing housing cap screws.
Step 3: Remove 6 3/4" bearing housing to frame bolts.
Step 4: Remove bearing housing from frame.
Step 5: Remove the retaining ring next to the front bearing.
Step 6: The bearings are pressed into the housing and must be pressed
back out.
Reassembly
Step 1: When installing new bearings into a bearing housing, first press
the front (large) bearing into the housing until it bottoms and
install the snap ring. With the bearing spacer in place, press
the rear bearing in until the spacer is snug between the two
bearings.
NOTE:
If the tub-back water-seal mating ring has been moved
it must be cleaned and resealed
77
Part # 8533-081-001 1/18