Dexter Laundry T900 Parts & Service Manual page 59

C-series vended washers
Table of Contents

Advertisement

Fault
Description
COMM
VFD Non
ERROR 4
Existent or
communication
fault
COMM
VFD
ERROR 5
Communication
Fault
COMM
VFD
ERROR 6
Communication
Fault
Customer Action
Condition
This error is when the washer controller cannot
communicate with the drive.
Delay
Delay time is 2 seconds
Action
Stop the machine and clear the cycle. Keep
the door locked until the machine has stopped
moving and then unlock the door.
Solution
Check the data communication
cable between the washer computer
and the variable frequency drive
(VFD).
did not become unplugged during operation.
Step 2: Make sure that the cable is not being
pulled sideways at either the washer controller,
or the VFD, plug end. If both ends of the
communications cable are plugged in the
washer computer and VFD and there is no
tension on the communications cable pulling
it from side to side, then replace the cable.
Step 3: Inspect both female connection points
at PCB controller and at VFD. These may need
replacement if they cannot be reset.
Condition
This error is a data error on communications
between the controller and the VF drive
Delay
Delay time is 12 seconds.
Action
Stop the machine and clear the cycle. Keep
the door locked until the machine has stopped
moving and then unlock the door.
Solution
The CE errors are communications errors. Data
Cable noise can cause the majority of these
errors. Check VFD fault light before turning
off power. Check the data cable between the
controller and the drive. Replace data cable if
it appears damaged and fault appears again.
Please note that this fault will occur if you
turned main power off and on to quickly. (See
Note below)
Condition
This error indicates that a VFD exception error
is set
Delay
Occurs following the "DELAY" error (see
corresponding detail)
Action
Stop the machine and clear the cycle. Keep
the door locked until the machine has stopped
moving and then unlock the door.
Solution
The washer will not restart until the power is
removed and re-applied.
Step 1: Make sure the cable
Part # 8533-081-001 1/18
59

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wc0900-xa12ecxT1200Wc1200-xa12ecx

Table of Contents