Table of Contents
Advertisement
Topic
INTRODUCTION ............................................................................................................................................................................ 2
ROGUE2 PARTS LIST ..................................................................................................................................................................... 3
TOOLS REQUIRED FOR SLIDE ASSEMBLY: .................................................................................................................................... 5
ASSEMBLY INSTRUCTIONS ........................................................................................................................................................... 7
ASSEMBLY INSTRUCTIONS FOR ON DECK MOUNTING .............................................................................................................. 13
IN-DECK MOUNTING .................................................................................................................................................................. 14
SLIDE PLUMBING INSTRUCTIONS .............................................................................................................................................. 14
MANUFACTURER'S PLACEMENT INSTRUCTIONS ....................................................................................................................... 16
ELECTRICAL BONDING................................................................................................................................................................ 18
Appendices: Left and Right CURVE FOOTPRINT......................................................................................................................... 19
INTRODUCTION
DANGER - FAILURE TO FOLLOW THESE WARNINGS, INSTRUCTIONS AND THE OWNER'S
MANUAL MAY RESULT IN SEROUS INJURY OR DEATH
THE ROGUE2 SLIDE IS DESIGNED AND MANUFACTURED FOR INSTALLATION AND USE ON INGROUND
SWIMMING POOLS ONLY. DO NOT INSTALL THE ROGUE2 SLIDE ON ABOVE GROUND POOLS,
HOUSEBOATS, BOAT DOCKS, FLOATING DOCKS OR PLATFORMS, OR OTHER BODIES OF WATER
SUCH AS LAKES, PONDS, RIVERS, ETC. PROPER ASSEMBLY, INSTALLATION, USE, AND SUPERVISION
IS ESSENTIAL FOR PROPER OPERATION AND TO REDUCE THE RISK OF SERIOUS INJURY OR DEATH.
CHECK INSIDE ALL BOXES AND PACKAGING MATERIALS FOR PARTS. BEFORE BEGINNING
ASSEMBLY, READ ALL INSTRUCTIONS AND IDENTIFY PARTS USING THE FIGURES AND PARTS LISTED
IN THIS DOCUMENT. IT IS CRITICAL THAT ALL PARTS BE CAREFULLY INSPECTED BY THE INSTALLER
PRIOR TO INSTALLATION TO ENSURE THAT NO DAMAGE OCCURRED IN TRANSIT AND THAT A
DAMAGED PART IS NOT USED. PROPER INSTALLATION CANNOT BE OVERSTRESSED, AS AN
IMPROPER INSTALLATION VOIDS S.R. SMITH'S WARRANTY AND MAY AFFECT THE SAFETY OF THE
USER.
INSTALLER MUST GIVE TO SLIDE OWNER: ROGUE2 SLIDE INSTALLATION AND OWNER'S MANUAL,
THE WARRANTY CARD, AND ANSWER ALL QUESTIIONS REGARDING SAFE AND PROPER USE AND
SLIDE MAINTENACE.
FOR COMPLETE SLIDE SAFETY INFORMATION REFER TO THE OWNER'S MANUAL.
INSTALLED ROGUE2 STRUCTURAL & INSTALLATION CHECKLIST (INSTALLER TO
REVIEW WITH SLIDE OWNER UPON COMPLETION OF SLIDE INSTALLATION)
1.
INSPECT THE RUNWAY FOR VISIBLE CRACKS OR TEARS.
2. INSPECT THE SLIDE FOR SHARP EDGES, PROTRUSIONS, CRACKS OR TEARS.
3. INSPECT ALL FASTENERS TO MAKE SURE THEY ARE FULLY TIGHTENED.
4. INSPECT THE LADDER FOR RIGIDITY AND ATTACHMENT.
5. MEASURE THE FOLLOWING DIMENSIONS AND COMPARE WITH THE MANUFACTURER'S
PLACEMENT INSTRUCTIONS ON PAGES 17 AND 18.
MEASURE THE DEPTH OF WATER IN FRONT OF THE SLIDE EXIT. (4'-6" (1371 mm) MIN.
DEPTH AT A DISTANCE OF 4'-6" (1371 mm) FROM EXIT END OF SLIDE.)
MEASURE THE HEIGHT OF THE SLIDE RUNWAY EXIT ABOVE THE WATER. (20" (508 mm)
MAX.)
MEASURE THE DISTANCE BETWEEN THE SLIDE CENTERLINE AND THE EDGE OF
OTHER POOL EQUIPMENT.
6. OBSERVE THE POSITION OF THE EXIT OF THE SLIDE AS SHOWN IN FIGURES 17, 18 AND 19 ON
PAGES 17 AND 18.
Table of Contents
2
Page #
Advertisement
Table of Contents
