Table of Contents
Advertisement
e.
Go back and fully tighten the outside bolts before completely tightening the center bolts.
Tighten until the plastic surfaces come into contact and are secure. Do not over tighten the
hardware.
2) Insert the slide legs into the leg sockets. See Figure 5.
a. The two short legs go into the front sockets nearest the slide exit.
b. The shorter of the two longer legs goes into the socket on the inside curve of the slide.
c. Be sure to insert the end of the legs that do not have the pre-drilled holes into the leg
sockets.
d. Do not attach the legs permanently at this point.
e. Tape the legs to the leg sockets so that they will be held in place when turning the slide
upright.
3) Insert the top of the slide ladder all the way into the two sockets in the slide. Use clamps to
temporarily hold the ladder in place while the slide is being turned upright. See Figure 6.
NOTE: The top of the ladder is the end with the side rails cut square.
Figure 6
Guide slots
8
Figure 5
Advertisement
Table of Contents
